Mitsubishi Electric MELSEC iQ-F Series - Page 27

4 FUNCTIONS
4.1 Function List
25
4
Others
Function Description Availability Reference
Master
station
Local
station
"CC-Link IE TSN
Configuration"
window
Parameter setting of a
device station
Sets parameters of device stations (the number of points and
assignment of link devices) in the master station.
Page 140
Parameter
setting of a
device station
Detection of
connected/
disconnected devices
Detects connected device stations, and displays the stations
on the "CC-Link IE TSN Configuration" window.
Page 144
Connected/
disconnected
module
detection
Parameter processing
of a device station
Reads and saves the parameters from the device station, and
writes the saved parameters to the device station.
Page 146
Parameter
processing of a
device station
Command execution
to device stations
Executes commands (Error clear request, Error history clear
request) to a device station.
Page 148
Command
execution to
device stations
Reserved station setting Reserved stations are device stations to be included among
the stations in the network for future extension and set in the
parameters. These stations are not connected to actual
networks, and are not regarded as faulty stations even if they
are not connected.
By setting a reserved station, link device assignment will not
change even if the device station is connected (or the
reservation is cleared). Therefore, modification of the program
is not required.
Page 140 "CC-
Link IE TSN
Configuration"
Window
Error invalid station setting An error invalid station is a device station that is set to be not
detected as a faulty station by the master station. It is also set
when a device station is to be replaced during data link.
Page 140 "CC-
Link IE TSN
Configuration"
Window
Device station parameter automatic
setting
This function saves parameters of the device station in the
master station, and automatically sets the parameters when
the device station is connected or returned to the network.
Page 62
Device station
parameter
automatic
setting
Station number/IP address setting using a
program
Sets a station number and IP address to the own station
which has no station number and IP address setting using a
program. This function allows project data items of stations
with the same program and network parameters (excluding
the station numbers and IP addresses) to be the same,
leading to reduced development work hours.
Page 151
Other
dedicated
instructions