Mitsubishi Electric MELSEC-Q/L - Low-Speed Timer, High-Speed Timer, Low-Speed Retentive Timer, High-Speed Retentive Timer

150
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
Low-speed timer, high-speed timer, low-speed retentive timer,
high-speed retentive timer
OUT T, OUTH T, OUT ST, OUTH ST
*1 The value setting for the timer cannot be designated indirectly.
See Page 105 Indirect Specification for further information on indirect designation.
*2 Timer values can be set only as a decimal constant (K). Hexadecimal constants (H) and real numbers cannot be used for timer settings.
(D): Timer number (bit)
Setting value Value set for timer (BIN 16 bits
*1
)
Setting
data
Internal device R, ZR J\ U\G Zn Constant
K
Others
Bit Word Bit Word
(D)  (Only T,
ST)
 
Set value  (Other
than T, ST,
C)
 
*2

Basic
Process
High
performance
Redundant Universal LCPU
K50
D10
K50
H
D10H
K50
D10
K50H
D10H
OUT T
OUTH T
OUT ST
OUTH ST
T0
T0
T0
T0
ST0
ST0
ST0
ST0
Set value
Setting in the range
from 1 to 32767 is valid.
Set value
Data register value in the
range from 1 to 32767 is valid.
Set value
Setting in the range
from 1 to 32767 is valid.
Set value
Data register value in the
range from 1 to 32767 is valid.
Set value
Setting in the range
from 1 to 32767 is valid.
Set value
Data register value in the
range from 1 to 32767 is valid.
Set value
Setting in the range
from 1 to 32767 is valid.
Set value
Data register value in the
range from 1 to 32767 is valid.
Command
Command
Command
Command
Command
Command
Command
Command
(High-speed retentive timer)
(Low-speed timer)
(High-speed timer)
(Low-speed retentive timer)
Timer number (D)
Timer number (D)
Timer number (D)
Timer number (D)
Timer number (D)
Timer number (D)
Timer number (D)
Timer number (D)
@D0
T0
Indirect designation is
not permitted.