156
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
Annunciator output
OUT F
• Operation results up to the OUT instruction are output to the designated annunciator.
• The following responses occur when an annunciator (F) is turned ON.
• If the value of SD63 is 16 (which happens when 16 annunciators are already ON), even if a new annunciator is turned ON,
its number will not be stored at SD64 to SD79.
• The following responses occur when the annunciator is turned OFF by the OUT instruction.
• The number of basic steps of the OUT F instruction is 2.
• For the LED which turns on when an annunciator is turned on, refer to the following table depending on the CPU module
used.
For details of annunciators, refer to the User's Manual (Function Explanation, Program Fundamentals) for the
CPU module used.
• There is no operation error in the OUT instruction.
(D): Number of the annunciator to be turned ON (bits)
Setting
data
Internal device R, ZR J\ U\G Zn Constant Others
Bit Word Bit Word
(D) (Only F)
• The "USER"/"ERR." LED goes ON.
• The annunciator numbers which are ON (F numbers) are stored in special registers (SD64 to SD79).
• The value of SD63 is incremented by 1.
• The coil goes OFF, but there are no changes in the status of the "USER" / "ERR." LED and the contents of the values stored in SD63 to SD79.
• Use the RST F instruction to make the "USER"/"ERR." LED go OFF as well as to delete the annunciator which was turned OFF by the OUT F instruction
from SD63 to SD79.
CPU module LED which turns on
High Performance model QCPU, Process CPU, Redundant CPU, Universal model QCPU, LCPU "USER" LED
Basic model QCPU "ERR." LED
Basic
Process
High
performance
Redundant
Universal
LCPU
F35
OUT F
Annunciator number (D)
Command
To Next Page
Loading...
