7 APPLICATION INSTRUCTIONS
7.6 Structure Creation Instructions
459
7
• To force an end to the repetitious execution of the FOR to NEXT loop during the execution of the loop, insert
a BREAK instruction. See Page 460 Forced end of FOR to NEXT instruction loop for details concerning the
use of the BREAK instruction.
• Use the EGP/EGF instruction to perform the pulse operation of an index-modified program between the
FOR and NEXT instructions. Note, however, that rise and fall instructions are not available on the operation
output side. Refer to Page 146 Pulse conversion of edge relay operation results for details of the EGP/EGF
instruction. The program samples are shown below:
• Branching into a FOR to NEXT loop using a JMP or other branch instruction from the outside of the FOR to
NEXT loop is not possible.
To Next Page
Loading...
