Mitsubishi Electric MELSEC-Q/L - Page 568

566
7 APPLICATION INSTRUCTIONS
7.11 Character String Processing Instructions
Operation error
• In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into SD0.
Error
code
Error details Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
4100 The (S1) value is not within the following range:
0, 2
-126
 | (S1) | < 2
128
The format specified by (S2) is other than 0 and 1.
The total number of digits specified by (S2) + 1 is outside the following
ranges:
[When using decimal point format]
• When the number of decimal fraction digits is "0": Total number of digits 
2
• When the number of decimal fraction digits is not "0": Total number of
digits  (Number of decimal fraction digits + 3)
[When using exponent format]
• When the number of decimal fraction digits is "0": Total number of digits 
6
• When the number of decimal fraction digits is not "0": Total number of
digits  (Number of decimal fraction digits + 7)
The number of digits for the decimal fraction portion specified by (S2) +2 is
outside the following ranges:
• When using the decimal point format: Number of decimal fraction digits 
(Total number of digits -3)
• When using the exponent format: Number of decimal fraction digits 
(Total number of digits -7)
The value in more than 24 digits was specified.

4101 The range of the devices that store the character string specified in (D)
exceeds the range of the corresponding device.

The range of the device specified by (S2) exceeds the range of the
corresponding device.

4140 The (S1) value is not within the following range:
0, 2
-126
 | (S1) | < 2
128
The specified device value is -0, unnormalized number, nonnumeric, and .
