Mitsubishi Electric MELSEC-Q/L - Page 706

704
7 APPLICATION INSTRUCTIONS
7.15 Clock Instructions
Program example
• The following program compares the data stored in D0 with the data (hour, minute, and second) stored in D10, and makes
Y33 be conductive status when the data stored in D0 meet the data stored in D10.
• The following program compares the data stored in D0 with the current time data (hour and minute), and makes Y33 be
conductive status when the data stored in D0 do not meet the current date data, when M0 is turned on.
• The following program compares the data stored in D0 with the data (hour and second) stored in D10, and makes Y33 be
conductive status when the data value stored in D10 is smaller than the data value stored in D0, when M0 is turned on.
• The following program compares the data stored in D0 with the current time data (hour), and makes Y33 be conductive
status when the value of the current time data is the data value stored in D0 or larger.
[Ladder Mode] [List Mode]
[Ladder Mode] [List Mode]
[Ladder Mode] [List Mode]
[Ladder Mode] [List Mode]
Step
Instruction
Device
Step
Instruction
Device
Step
Instruction
Device
Step
Instruction
Device