804
7 APPLICATION INSTRUCTIONS
7.19 Other Instructions
• In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into SD0.
• The program which reads the ten points of data from D100 to the device data storage file in the standard ROM when M0
turns ON.
Error
code
Error details Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
2410 The device data storage file is not set at "PLC file" of PLC parameter.
4100 The address specified in n1 is out of the standard ROM range.
The address of n2, specified in n1, is out of the standard ROM range.
The value specified in n2 is 0 or a negative value.
4101 The range of n2 exceeds that of the device specified in (D).
[Ladder Mode] [List Mode]
Instruction
Device
Step
To Next Page
Loading...
