10 MULTIPLE CPU HIGH-SPEED TRANSMISSION DEDICATED INSTRUCTIONS
10.3 Reading Devices from Another CPU
879
10
• Digit specification of bit device is possible for n, (S2), and (D1). Note that when the digit specification of bit device is made
to (S2) or (D1), the following conditions must be met.
• Execute this instruction after checking that the read target CPU is powered on. Not doing so may end up no processing.
• If changing a range of the device specified at setting data between after execution of the instruction and turn-on of the
completion device, data to be stored by system (completion status, completion device) cannot be stored normally.
• Digits are specified by 16 bits (4 digits).
• The start bit device is multiples of 16 (10H).
To Next Page
Loading...
