V5A51 -
Transmission
23E-5-26
Moving amount mm Pressure plate
Thickness mm ID symbol Part No.
1.5 or more - less than 1.7 1.8 E MD759425
1.7 or more - less than 1.9 2.0 D MD759426
1.9 or more - less than 2.1 2.2 C MD759427
2.1 or more - less than 2.3 2.4 B MD759428
2.3 or more - less than 2.5 2.6 A MD759429
2.5 or more - less than 2.7 2.8 0 MD759430
2.7 or more - less than 2.9 3.0 1 MD759431
(13)Remove the parts installed in steps 24 (1) to (12).
25. Apply Vaseline or petrolatum jelly on the thrust bearing
No.7, and then install the bearing on the rear side of
the low/reverse annulus gear.
Caution
D
Take care not to mistake the thrust bearing No.7
mounting direction.
26. Install the low/reverse annulus gear.
Caution
D
Make sure that the thrust bearing No.7 attached
to the rear side of the low/reverse annulus gear
does not fall off.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Thrust
bearing No.7
Thrust bearing
No.7
To Next Page
Loading...
Need help?
General
