V5A51 -
Transmission
23E-5-35
67. Install the parking gear and snap ring.
Caution
D
Install the parking gear so that the side without
the spline cut faces the transmission side.
D
Heat the parking gear to 160 - 180
_
C, and shrink
fit up to the stepped section of the output shaft.
68. Install th e park/neutral position switch and manual control
lever.
69. Install the output shaft speed sensor.
70. Install the input shaft speed sensor.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Parking
gear
Snap ring
Transmission
side
Park/neutral
position switch
Manual control lever
To Next Page
Loading...
Need help?
General
