MKN FlexiChef - Emergency Off and Nameplate Information

Troubleshooting
104 Operating instructions
Error Possible causes Remedy
The safety temperature limiter
has tripped
The unit does not heat up
Electronic fault or error in heating
system
• Reset the safety temperature limiter:
– Press the
MultiPort cover panel on
the control arm of the unit.
– Press
Reset 1 button briefly and
then
Reset 2 button briefly.
Lid closing is interrupted
Lid opens again
Object between lid and pan • Remove object.
• Start equipment function again.
Collision with the locking pin • Realign unit, contact customer service.
Lid or pan move jerkily Unit aligned incorrectly • Realign unit, contact customer service.
The time is not running for
pressure cooking
Pressure cannot be built up fully • Disconnect the unit from the electric
mains.
• Check the lid seal for damage and re-
place if necessary.
• Contact customer service.
Steam escapes from the pan
during pressure cooking
Seal defective • Check the lid seal for damage and re-
place if necessary.
SpaceClean cleaning is
cancelled or restarts
Shortage of water
Water pressure is not sufficient • Perform a test:
– At least 13 litres of warm water
must flow into the pan in one
minute.
6.1.1 Deactivating emergency off
Activating the Emergency off switch interrupts the electrical
supply.
For pressure cooking mode: pressure in the pan is not released.
Requirement Emergency off activated
For pressure cooking mode: switch the "ON OFF" button to "OFF".
Turn the Emergency off switch to the right.
Emergency off switch is unlocked.
For pressure cooking mode: pressure is released.
Touchscreen starts power-on process.
Unit is ready for use as soon as the main menu is displayed on
the touchscreen.
6.2 Nameplate
When contacting Customer service, please always provide the
following data from the nameplate:
Serial number
(SN)
Type number
(TYP)
4426201-20ABBE-A