Cleaning and caring for the unit
98 Operating instructions
5.2 Remove rust spots
• Remove fresh rust spots with a mild abrasive or fine sandpaper.
• Always remove rust spots completely.
• Expose treated areas to fresh air for at least 24 hours. During this
time, do not allow any contact with greases, oils or foods so that a
new protective layer can form.
5.3 Cleaning the housing
Requirement Unit switched off and cooled down
Clean the housing with warm water and commercially available
washing-up liquid.
5.4 Cleaning the operating elements and control panel
ATTENTION
Risk of physical damage from improper cleaning
• Do not clean the surface with highly abrasive or chemically
aggressive cleaning agents.
• Do not clean the surface with highly abrasive sponges.
Requirement Unit switched off
Clean the operating elements and control panel with a damp cloth
and commercially available cleaning agent.
4426201-20ABBE-A
To Next Page
Loading...
