Operating the unit
43Operating instructions
The water quantity can be entered directly in litres or as a fill
quantity. The "ReadyXpress" selection provides the optimal
water quantity in the pressure cooking mode.
If no water quantity is set ("000" litres), the water inlet must be
controlled manually.
3. Swipe to set the water quantity.
4. Tap the "Start" button.
The drain closes, if it was open.
Water runs into the pan.
The "Start" button is replaced with the "Pause" and "Stop"
buttons.
The
Water quantity
display is updated.
The process can be cancelled at any time by tapping the "Stop"
button or interrupted by tapping the "Pause" button. When the
process is paused, the "Pause" button is replaced with the
"Continue" button.
The process ends automatically when the set water quantity has
run into the pan or when the "Total" water meter reaches the
maximum fill quantity.
5. Wait for the set water quantity to be supplied or tap the "Stop"
button.
The water inlet stops.
The pan is filled with the set water quantity.
ATTENTION
Risk of physical damage through overflowing water
• Monitor the water inlet and do not leave the unit unattended.
4426201-20ABBE-A
To Next Page
Loading...
