Moeller DF51 - Page 166

Serial interface (Modbus)
10/05 AWB8230-1541GB
162
0019 RUN mode signal ro 0 = OFF
1 = ON
001A Force data ro 0 = normal status
1= force
001B CRC fault ro 0 = no fault signal
2)
1 = fault signal
001C Overflow error ro
0 = no fault signal
2)
1 = fault signal
001D Bus frame fault ro 0 = no fault signal
2)
1 = fault signal
001E Parity fault ro 0 = no fault signal
2)
1 = fault signal
001F Checksum error signal ro 0 = no fault signal
2)
1 = fault signal
1) The default state is On when one of the control signal terminals (digital
inputs) or a coil is set to On. The control signal terminals have the
highest priority. If the master can not reset the coil, it must be switched
off through the control signal terminals to set the coil status to Off.
2) Transmission errors are held until they are reset. Errors can be reset
during frequency inverter operation.
3) Do not use. For DV51 only.
Coil
number
Name Access rights
Description
hex