EasyManua.ls Logo

Moeller DF51 - Features of the DF51

Moeller DF51
241 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10/05 AWB8230-1541GB
15
2 Engineering
This section describes the „Features of the DF51“ and the
requirements and standards relating to the following issues:
Connection to power supply
EMC Directive for PDS drive systems
Features of the DF51
General
Standards EN 50178, IEC 61800-3, EN 61800-3 incl. A11
Ambient temperature
1)
Operating temperature °C –10 to +40 with rated current I
e
without reduced performance, up to 50 with clock
frequency reduced to 2 kHz and output current reduced to 80 % I
e
Storage, transportation °C –25 to +70
Mechanical shock resistance Impacts and vibration: up to 5.9 m/s
2
(0.6 g) at 10 to 55 Hz
Pollution degree VDE 0110 Part 2, pollution degree 2
Climatic proofing Class 3K3 according to EN 50178 (non-condensing, average relative humidity 20 to
90 %)
Installation altitude m 0 to 1000 m above sea level
Mounting position Vertically suspended
Free surrounding areas 100 mm above and below device
Emitted interference IEC/EN 61800-3 (EN 55011 group 1, class B)
Noise immunity IEC/EN 61800-3, industrial environment
Insulation resistance Overvoltage category III according to VDE 0110
Leakage current to PE mA
> 3.5 (to EN 50178)
Degree of protection IP 20
Protection against direct contact Finger and back-of-hand proof
Protective isolation against switching circuitry Safe isolation from the mains. Double basic isolation (to EN 50178)
Protective measures
Overcurrent, earth fault, overvoltage, undervoltage, overload, overtemperature,
electronic motor protection: J monitoring and PTC input (thermistor or thermostat)
Power section
DF51-320-…
Rated operational voltage V AC 230
Rated voltage U
e
V 3 AC 180 to 264 V g 0 %
DF51-322-…
Rated operational voltage V AC 230
Rated voltage U
e
V 1/3 AC 180 to 264 V g 0 %
DF51-340-…
Rated operational voltage V AC 400
Rated voltage U
e
V 3 AC 342 to 528 V g 0 %
Mains frequency Hz
50/60 (47 to 63 g 0 %)
Modulation method
Pulse width modulation (PWM), U/f characteristic control
Switching frequency
5 kHz, adjustable from 2 to 14 kHz
Output voltage V 3 AC U
e
Output frequency Hz 0 – 50, max. 400

Table of Contents

Related product manuals