Moeller DF51 - Initialization (Restoring Default Settings)

Setting parameters
10/05 AWB8230-1541GB
144
Initialization (restoring default settings)
You can perform the following initialization actions:
• Clearing the fault register.
• Restoring the default parameter settings
• Activating country-specific settings.
To clear the fault register and/or to restore the factory default
settings, proceed as follows:
X Make sure that PNU b085 is set to the correct country version.
X In PNU b085 enter the value 01 {02} and confirm your input
with the ENTER key.
X Under PNU b084 enter the corresponding value (00, 01 or 02).
X Press the ENTER key to save the value.
X On the keypad, press and hold arrow key Ú and the PRG key at
the same time.
X While holding the arrow and PRG keys, briefly press the STOP
key.
The keypad’s display shows EU (if b085 = 01) or USA (if
b085 = 02).
X Now release all keys again.
In the display’s left field the individual segments light up in
sequence. At the same time, the Hz, START, RUN and the
potentiometer LEDs light up. When initialization is completed, all
LEDs go out and the display shows d001 (frequency indication).
Initialization is now complete.
You can now press the PRG key to return to the frequency
indication (Hz) and ENTER to save this display preference.
h
With the initialization, all parameters are reset to heir
factory default values.
Figure 150:Initializing the country-specific default settings for Europe
PRG
POWER
PRG
ENTER
POWER
h
Caution!
For DF51-322 and DF51-340 only the value 01 (EU) is
permissible, and for DF51-320 only the value 02 (USA).
h
Carry out this initialization step after setting PNU b084
and before pressing any keys only when needed.
h
The default settings can be recalled only in STOP mode
(a PNU b151 = 00, page 142).
PNU Name RUN b031
= 10
Value Function DS
b084 Initializing –
function
– – 00: TRP: Clear fault register 00
01: DATA: Load default settings (DS)
02: ALL: Clear fault register and load default settings (DS)
b085 Initialization,
country-
specific default
settings
– – 00 Japan 01
{02}
1)
01 Europe
02 USA
1) 02 forDF51-320-…