Moeller DF51 - Page 6

Contents
10/05 AWB8230-1541GB
2
Electrical connection 34
– Connecting the power section 34
– Connecting a signalling relay 41
– Connecting the control signal terminals 42
4Using the DF51 49
Operational warnings 49
Block diagram 50
Initial starting 51
– Standard operation, actuation with default settings 52
– Default functions of output terminals 54
Keypad 55
– Navigation within the menu 55
– Quick parameter selection 56
– Menu overview 56
– Setting the display parameters 57
– Examples for changing parameters 58
Using the keypad 61
– Controlling the DF51 with keypad DEX-KEY-6 61
5 Setting parameters 63
Motor data 64
Motor control 65
– U/f characteristic 65
– Limit and target values 66
– Automatic voltage regulation (AVR) 67
– Output voltage and voltage boost 68
Reference and control signal inputs 69
– Basic parameters 72
– Control signal terminal overview (input) 74
– Start signal input 77
– Parameterizable digital inputs 77
– Controller inhibit and coasting (free run stop – FRS) 79
– Three-wire control (STA – STP – F/R) 80
– Control signal terminal modus (F-TM) and keypad
(OPE) 81
– Second parameter set (SET) 83
– Special functions in the second parameter set
(SP-SET) 83
– Specifying reference frequencies 86
– Changing over time ramps 93
– Minimum and maximum operating frequency 95
– Suppressing frequency ranges 96
– Fixed frequencies 97
– Motor potentiometer 99
– Jog mode 101
Actual value and status signals 102
– Control signal terminal overview (output) 102
– Analog output (AM) 104
– Parameterizable digital outputs 105
– Signalling relay K1 (terminals K11, K12, K14) 107
– RUN signal 109
– Frequency value signal (FA1/FA2) 110