Using the DF51
10/05 AWB8230-1541GB
60
Here is a short overview of the most important parameters. This
overview is supplied on a self-adhesive foil with every device and
when necessary can be affixed, for example, to the inside of the
terminal shroud.
Table 19: Brief description of the parameters
Figure 62: Label for the terminal shroud
MONITOR
Display values USER SETTING
Preset user values
d001 Output frequency Output frequency in Hz
d002 Output current Output current in A
d080 Trip counter Total number of occurred faults
d081 Trip monitor 1 First fault (last fault warning)
d082 Trip monitor 2 Second fault
d083 Trip monitor 3 Third fault
BASIC FUNCTION
Basic functions
F001 Output frequency Frequency reference value
F002 Acceleration time
Acceleration time 1
F003 Deceleration time Deceleration time 1
F004 Sense of rotation FWD/REV
Direction of rotation
A001 Frequency source Frequency reference value definition
A002 Run command source Start signal input
A003 Base frequency Base frequency
A004 Maximum frequency End frequency
ERROR Error messages
E 01 Overcurrent (Const.) Overcurrent in the power output element in static operation
E02 Overcurrent (Decel.)
Overcurrent in the power output element during the delay
E03 Overcurrent (Accel.)
Overcurrent in the power output element during the acceleration
E05 Overload
Overload
E07 Overvoltage Overvoltage
E09 Undervoltage Undervoltage
E14 Ground fault Ground fault
E21 Thermal trip Overtemperature
MONITOR
BASIC FUNCTION ERROR
Output frequency
Output frequency
Acceleration time
Deceleration time
Sense of rotation FWD/REV
For the other discription of Monitor/Setting, see manual
USER SETTING
Output current
Trip counter
Trip monitor 1
Trip monitor 2
Trip monitor 3
Frequency source
Base frequency
Maximum frequency
Run command source
Overcurrent (Const.)
Overcurrent (Decel.)
Overcurrent (Accel.)
Overload
Overvoltage
Undervoltage
Ground fault
Thermal TRIP
To Next Page
Loading...
