NPort W2150/2250 Plus Series User’s Manual Web Console: System Management
8-3
Overview
This chapter explains how to configure all settings located under the System Management folder
in the NPort web console.
System Management> Misc. Network Settings>
Accessible IP List
The Accessible IP List page is located under Misc. Network Settings in the System
Management folder. This page is used this restrict access to the NPort by IP address. Only IP
addresses on the list will be allowed access to the NPort. You may add a specific address or range
of addresses by using a combination of IP address and netmask, as follows:
To allow access to a specific IP address
Enter the IP address in the corresponding field; enter 255.255.255.255 for the netmask.
To allow access to hosts on a specific subnet
For both the IP address and netmask, use 0 for the last digit (e.g., “192.168.1.0” and
“255.255.255.0”).
To allow access to all IP addresses
Make sure that Enable the accessible IP list is not checked.
To Next Page
Loading...
Need help?
General
