NPort W2150/2250 Plus Series User’s Manual Web Console: Serial Port Settings
7-33
Primary and Secondary Host Address
Default
Options
IP address (e.g., “192.168.1.1”)
Description
These fields designate permanent hosts to which the terminal will always be
connected. Auto-Link Protocol must be configured to Telnet or Rlogin in order
to specify a permanent host.
Telnet TCP Port
Default
23
Options
0 to 9999
Description
This field specifies the TCP port number for Telnet sessions. The default TCP
port number for Telnet is 23.
Terminal Type
Default
ansi
Options
free text (e.g., “ansi” or “vt100”)
Description
This field specifies terminal type information that is transmitted before a
connection is established. Some older terminal applications require this. You
may need to refer to the server’s documentation to determine the appropriate
terminal type. For most applications, this setting will be unnecessary and will
have no effect.
Quit
Default
(^E)0x05
Options
Description
This field defines the quick key for quitting a session. “^E” refers to Ctrl-E.
Authentication Type
Default
None
Options
None, Local, RADIUS
Description
This field specifies the method used to verify a user’s ID and authorization.
None: No authentication is required to open a terminal session.
Local: The user ID and password must match the local user’s table, which is
found under System Management> Misc. Network Settings> User Table.
RADIUS: The user ID and password must be authenticated by the RADIUS
server, which is specified under System Management> Misc. Network Settings>
Authentication Server.
To Next Page
Loading...
Need help?
General
