NPort W2150/2250 Plus Series User’s Manual Web Console: System Management
8-10
Group Event
System System Cold Start, System Warm Start
Network DHCP/BOOTP, Get IP/Renew, NTP, Mail Fail, NTP Connect Fail, DHCP Fail,
IP Conflict, Config Import, Config Export
Config Login Fail, IP Changed, Password Changed, Config Changed, Firmware
Upgrade, SSL Key Improt, Config Import, Config Export
Op Mode Connect, Disconnect, Authentication Fail, Restart
System Management> Auto Warning Settings> Event
Settings
The Event Settings page is located under Auto Warning Settings in the System Management
folder. This is where you specify how the NPort will notify you of system and configuration
events. Depending on the event, different options for notification are available, as shown above.
Mail refers to sending an e-mail to a specified address. Trap refers to sending an SNMP trap.
Event Description
Cold start The NPort was powered on, or was restarted after a firmware
upgrade.
Warm start The NPort restarted without powering off.
Console login auth fail An attempt has been made to open the web, Telnet, or serial
console, but the password was incorrect.
IP changed The IP address has been changed.
Password changed The password to the console has been changed.
To Next Page
Loading...
