NPort W2150/2250 Plus Series User’s Manual Web Console: Serial Port Settings
7-29
Primary and Secondary Host Address
Default
Options
IP address (e.g., “192.168.1.1”)
Description
These fields designate permanent hosts to which the terminal will always be
connected. Auto-Link Protocol must be configured to Telnet or Rlogin in order
to specify a permanent host.
Telnet TCP Port
Default
23
Options
0 to 9999
Description
This field specifies the TCP port number for Telnet sessions. The default TCP
port number for Telnet is 23.
Terminal Type
Default
ansi
Options
free text (e.g., “ansi” or “vt100”)
Description
This field specifies terminal type information that is transmitted before a
connection is established. Some older terminal applications require this. You
may need to refer to the server’s documentation to determine the appropriate
terminal type. For most applications, this setting will be unnecessary and will
have no effect.
Max. Sessions
Default
4
Options
1 to 8
Description
This field specifies the maximum number of simultaneous terminal sessions
allowed through the serial port.
Change Session
Default
(^T)0x14
Options
Description
This field defines the quick key for switching sessions. “^T” refers to Ctrl-T.
Quit
Default
(^E)0x05
Options
Description
This field defines the quick key for quitting a session. “^E” refers to Ctrl-E.
Break
Default
Options
Description
This field defines the quick key for sending a break signal.
To Next Page
Loading...
Need help?
General
