NPort W2150/2250 Plus Series User’s Manual Web Console: Serial Port Settings
7-5
Mode
Default
(depends on Application)
Options
RealCOM, RFC2217, TCP Server, TCP Client, UDP, Pair Connection Master,
Pair Connection Slave, Terminal (TERM_ASC), Terminal (TERM_BIN)
Description
Along with Application, this field specifies the serial port’s operation mode, or
how it will interact with network devices. Depending on how Application is
configured, different options are available for Mode. Depending on how Mode
is configured, additional settings will be available for configuration. For an
introduction to the different operation modes, please refer to Chapter 4. To
configure Ethernet Modem or Reverse Terminal operation, set Application
accordingly.
RealCOM: This serial port will operate in RealCOM mode.
RFC2217: This serial port will operate in RFC2217 mode.
TCP Server: This serial port will operate in TCP Server mode.
TCP Client: This serial port will operate in TCP Client mode.
UDP: This serial port will operate in UDP mode.
Pair Connection Master: This serial port will operate in Pair Connection Master
mode.
Pair Connection Slave: This serial port will operate in Pair Connection Slave
mode.
Terminal (TERM_ASC): This serial port will operate in Terminal ASCII mode.
Terminal (TERM_BIN): This serial port will operate in Terminal binary mode.
To Next Page
Loading...
Need help?
General
