NPort W2150/2250 Plus Series User’s Manual Web Console: Network Settings
6-5
Speed
Default
Auto
Options
Auto, 10Mbps Half, 10Mbps Full, 100Mbps Half, 100Mbps Full
Description
This field specifies the network speed for the built-in Ethernet connection.
IEEE802.3 Ethernet supports auto negotiation of transfer speed. However, some
switches/hubs require that the communication speed be fixed at 100Mbps or
10Mbps.
ATTENTION
In dynamic IP environments, the NPort will send 3 requests every 30 seconds to the DHCP or
BOOTP server until the network settings have successfully been assigned. The first request will
time out after one second; the second request will time out after three seconds, and the third
request will timeout after five second. If the DHCP or BOOTP server is unavailable, the NPort
will use the factory default network settings.
Network Settings> WLAN Settings> WLAN
The WLAN page is located under WLAN Settings in the Network Settings folder. You can
modify IP configuration, IP address, Netmask, and Gateway for your WLAN.
The NPort W2150/2250 Plus Series supports IEEE 802.11a/b/g wireless network interfaces. The
supported IP configurations are static and dynamic (BOOTP, DHCP, or BOOTP+DHCP). Users
can set up the IP configuration with the serial console, or the Web/Telnet consoles through the
NPort’s Ethernet interface. For detailed information about configuring IP configuration, IP
address, Netmask, and Gateway, see the previous section, Ethernet Configuration.
To Next Page
Loading...
Need help?
General
