4 Product description
Maschinenfabrik Reinhausen GmbH 202242 8595028/00 ENTAPCON
®
250
Logging in, logging out and changing users
The control of access rights to device settings and parameters is user-
based. Several users can log in at the same time via the visualization and
access the device.
If you want to operate the device via the controls and visualization at the
same time, you have to log in on the device and via the visualization.
1. Select the LOGIN or CHANGE button in the status line.
2. Enter your user name and password and select the OK button.
ð The name of the logged-in user appears in the status line.
To log out as a user, proceed as follows:
► Press the LOGOUT button in the status line.
Navigation
If you are operating the device using the operating controls on the front
panel, you can use the keys and to navigate through the entire
menu. The menu currently selected has a blue border. To open the high-
lighted menu, you have to press the key. Pressing the key re-
turns you to the previous menu level.
If you are operating the device using the web-based visualization, you can
navigate by clicking on the appropriate buttons:
1. Go to Settings.
2. Go to Parameters.
3. Go to System.
4. Go to Time synchronization.
5. Select Time.
In these operating instructions, the path for navigating to a parameter is al-
ways shown in an abridged form: Go to Settings > Parameters > System >
Time synchronization.
Setting parameters
There are various ways to configure the settings, depending on the parame-
ter.
Selecting from a list
1. Use to navigate to the list and press .
2. Use or to highlight the list entry and press .
3. Press the Accept button to save the modified parameter.
To Next Page
Loading...
