MICROBROWSER AND ENHANCED PROGRAMMABLE KEYS
Using the Microbrowser
8 -98 DT820 Phone User Guide
To clear Handset forwarding using star codes
1 Lift the handset from the phone.
2 Dial *73.
All handset forwarding settings that are applied to the phone are cleared.
Note: This only clears the handset forwarding settings applied to the phone.
Administrator configured or system-level forwarding settings are not deleted.
CALL RECORDING
Note: If you select Start Recording Call and call recording is not enabled for you at
the system level, any Start Recording requests will fail and an error message
is displayed. Contact your system administrator if you need call recording
enabled.
START RECORDING CALL
• Press the Record key while on an active call to start an On-Demand recording.
STOP RECORDING CALL
• Press the Record key while an an On-Demand recording is active to stops recording.
SUPERVISE A CALL
SUPERVISE A CALL (BARGE-MONITOR)
The 3C system allows users to be granted rights to supervise an address group. If a
user has supervisor rights, they can monitor or barge into a call in progress on any
address in the group.
Selecting Supervise invokes the following XML page, allowing the user to select an
address group they have the right to supervise. Address groups that the user does
not have the right to supervise are not shown.
Note: Supervise shows only connected calls. Held calls are not shown.
Calls made to a secondary address are shown as if they were made to the
primary address.
Conference calls cannot be supervised.
When you select Supervise a Call, one of the following occurs:
• If you do not have Supervise privileges, an error is shown.
• If you have Supervise privileges, the Supervise page from the web server is
shown, listing the address groups available to the user.
To Next Page
Loading...
Need help?
General
