. . . . .
MICROBROWSER AND ENHANCED PROGRAMMABLE KEYS
Using Enhanced Programmable Keys
DT820 Phone User Guide 8 -113
When multiple calls are being recorded, the phone keeps track of all the calls that are
being recorded and updates the state of the Record key LED and the call recording
icon based on the call state.
SEND TO VM KEY
Send to Voice Mail
• While your phone is ringing, press the Send to VM key.
The call will be sent directly to your voice mail box and the phone will stop ringing.
HOT DESK KEY
To log in to a Hot Desk session
1 Press the Hot Desk key to open the Hot Desk login screen.
2 Enter your user name and password and press the OK soft key to log on to the phone.
The following screen is shown:
3 Press the OK to exit the screen.
The LED on the Hot Desk key turns off when you exit this screen.
Note: Due to system polling, it may take up to 5 minutes before your name and
extension are shown on the phone after you log in.
To log out of your Hot Desk session
1 While you are in a Hot Desk session, press the Hot Desk Key.
You are logged out off the phone.
2 Press OK to exit the screen.
The LED on the Hot Desk key turns off when you exit this screen.
TRUNK DIAL KEY
The Trunk Dial key is used to monitor the availability of trunks on your system, and to
place calls using specified trunks on the system.
TRUNK PRESENCE LEDS AND ICONS
Table 8.3 Trunk Presence LEDs and Icons
LED
DESI-Less
Icon State
Comments
LED is not
lit
Trunk not registered with the system
Trunk is not in service
To Next Page
Loading...
Need help?
General
