EasyManuals Logo

NEC DT820C ITY-8LCGX User Manual

NEC DT820C ITY-8LCGX
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
BASIC SETTINGS/CONFIGURATION
Basic Setup with the Menus and Cursor Pad
4 -36 DT820 Phone User Guide
downloaded from the boot server. If you select this entry, it will not be saved
and your ringtone settings will not change.
To enable an external headset
1 Connect the headset to the phone:
a. Insert the headset cord plug into the HEADSET connector on the back of the phone,
until you hear a click.
b. Thread the cord through the groove.
2 Press the Menu key on the phone.
3 Select 3 User Settings.
4 Select 2 Headset.
5 Select 1 Enable/Disable.
6 Select 2 Enable.
7 Press Enter b on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
To set external headset ringing (Optional)
You can set your phone to ring only through your external headset. The phone will not
ring from the telephone speaker when you have it set to ring to the headset.
Note: Hold reminder tone, soft ring, ringer volume, and preview of the User
Adjustable Ringtones on selection may not be supported by the headset.
They are only played on the phone speaker when Headset Ringing is set to
Phone or Phone and Headset.
1 Press the Menu key.
2 Select 3 User Settings.
3 Select 2 Headset.
4 Select 2 Ringing.
5 Do one of the following:
• To enable ringing on the headset only, select 2 Headset.
• To enable ringing on the headset and the phoneset, select 3 Phone and Headset.
6 Press Enter b on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
Note: The setting defaults to 1 Phone.
To set the Call Waiting volume
The Call Waiting Volume settings allow you to specify the call waiting tone volume for
the headset.
The range is 0 (no tone) to 19 (maximum tone volume). The default is 19.
Upon entering this screen, the keypad is locked in numeric entry mode. You cannot
change the keypad entry mode in this screen.
1 Press the Menu key.
2 Select 3 User Settings.
3 Select 3 Tone Volumes.
4 Select 1 Call Waiting Volume.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC DT820C ITY-8LCGX and is the answer not in the manual?

NEC DT820C ITY-8LCGX Specifications

General IconGeneral
BrandNEC
ModelDT820C ITY-8LCGX
CategoryTelephone
LanguageEnglish

Related product manuals