9
Procedure
1. Optional: If you access the server remotely, start an iLO remote console session.
2. Restart or power on the server.
3. Press F9 in the server POST screen.
The UEFI System Utilities start.
4. Click System Configuration.
5. Click BMC Configuration Utility.
6. Disable DHCP:
a. Click Network Options.
b. Select OFF in the DHCP Enable menu.
The IP Address, Subnet Mask, and Gateway IP Address boxes become editable. When
DHCP Enable is set to ON, you cannot edit these values.
7. Enter values in the IP Address, Subnet Mask, and Gateway IP Address boxes.
8. To save the changes and exit, press F12.
9. The BMC Configuration Utility prompts you to confirm that you want to save the pending
configuration changes.
10. To save and exit, click Yes - Save Changes.
11. The BMC Configuration Utility notifies you that iLO must be reset in order for the changes to
take effect.
12. Click OK.
iLO resets, and the iLO session is automatically ended. You can reconnect in approximately
30 seconds.
13. Resume the normal boot process:
a. Start the iLO remote console.
The BMC Configuration Utility is still open from the previous session.
b. Press ESC several times to navigate to the System Configuration page.
c. To exit the System Utilities and resume the normal boot process, click Exit and resume
system boot.
Managing local user accounts with the BMC Configuration Utility
Adding user accounts (BMC Configuration Utility)
Procedure
1. Optional: If you access the server remotely, start an iLO remote console session.
To Next Page
Loading...
Need help?
General