179
6. Configure the Ping Gateway on Startup setting.
7. To save the changes you made on the IPv4 Settings page, click Submit.
8. If you are finished configuring the iLO network settings on the General, IPv4, IPv6, and
SNTP tabs, click Reset to restart iLO.
It might take several minutes before you can re-establish a connection.
DHCPv4 settings
• Enable DHCPv4—Enables iLO to obtain its IP address (and many other settings) from a
DHCP server.
• Use DHCPv4 Supplied Gateway—Specifies whether iLO uses the DHCP server-supplied
gateway. If DHCP is not used, enter a gateway address in the Gateway IPv4 Address box.
• Use DHCPv4 Supplied Static Routes—Specifies whether iLO uses the DHCP server-supplied
static routes. If not, enter the static route destination, mask, and gateway addresses in the
Static Route #1, Static Route #2, and Static Route #3 boxes.
• Use DHCPv4 Supplied Domain Name—Specifies whether iLO uses the DHCP server-
supplied domain name. If DHCP is not used, enter a domain name in the Domain Name box
on the Network General Settings page.
• Use DHCPv4 Supplied DNS Servers—Specifies whether iLO uses the DHCP server-supplied
DNS server list. If not, enter the DNS server addresses in the Primary DNS Server,
Secondary DNS Server, and Tertiary DNS Server boxes.
• Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4-supplied
NTP service locations.
• Use DHCPv4 Supplied WINS Servers—Specifies whether iLO uses the DHCP server-
supplied WINS server list. If not, enter the WINS server addresses in the Use DHCPv4
Supplied WINS Servers, Primary WINS Server , and Secondary WINS Server boxes.
General IPv4 settings
• IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied
automatically. If DHCP is not used, enter a static IP address.
• Subnet Mask—The subnet mask of the iLO IP network. If DHCP is used, the subnet mask is
supplied automatically. If DHCP is not used, enter a subnet mask for the network.
• Gateway IPv4 Address—The iLO gateway IP address. If DHCP is used, the iLO gateway IP
address is supplied automatically. If DHCP is not used, enter the iLO gateway IP address.
• Static Route #1, Static Route #2, and Static Route #3—The iLO static route destination,
mask, and gateway addresses. If Use DHCPv4 Supplied Static Routes is used, these values
are supplied automatically. If not, enter the static route values.
IPv4 DNS server settings
• Primary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Primary DNS Server address.
• Secondary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Secondary DNS Server address.
To Next Page
Loading...
