NEC iLO 5 User Manual

267
Trap
number
Trap name
Description
9019
cpqSm2ServerPowerOnFailure
A request was made to power on the
server, but the server could not be
powered on because of a failure
condition.
9021
cpqSm2FirmwareValidationScanFailed
Firmware validation failure
happened on iLO/ IE/ SPS firmware
9022
cpqSm2FirmwareValidationScanErrorRepaired
Firmware integrity scan issue
reported has been repaired.
9023
cpqSm2FirmwareValidationAutoRepairFailed
Firmware recovery failure
11003
cpqHo2GenericTrap
Generic trap. Verifies that the SNMP
configuration, client SNMP console,
and network are operating correctly.
You can use the iLO web interface to
generate this alert to verify receipt of
the alert on the SNMP console.
11018
cpqHo2PowerThresholdTrap
A power threshold has been exceeded.
11020
cpqHoMibHealthStatusArrayChangeTrap
A change in the health status of the
server has occurred.
5022
cpqSasPhyDrvStatusChange
AMS detected a change in the status of
an SAS or SATA physical drive.
14004
cpqIdeAtaDiskStatusChange
AMS detected a change in the status of
an ATA disk drive.
16028
cpqFca3HostCntlrStatusChange
AMS detected a change in the status of
a Fibre Channel host controller.
18011
cpqNic3ConnectivityRestored
Connectivity was restored to a logical
network adapter.
18012
cpqNic3ConnectivityLost
The status of a logical network adapter
changed to Failed.
18013
cpqNic3RedundancyIncreased
AMS detected that a previously failed
physical adapter in a connected logical
adapter group returned to the OK
status.
18014
cpqNic3RedundancyReduced
AMS detected that a physical adapter
in a logical adapter group changed to
Failed status, but at least one physical
adapter remains in OK status.
169001
cpqiScsiLinkUp
AMS detected that an iSCSI session is
up.
169002
cpqiScsiLinkDown
AMS detected that an iSCSI session
is down.

NEC iLO 5 Specifications

General

Brand	NEC
Model	iLO 5
Category	Server
Language	English