299
• Check to see if a firewall is active on the directory server.
• Check for network routing issues.
Connect to Directory Server test reports a failure
Symptom
The Connect to Directory Server test reports the status Failed.
Cause
iLO failed to initiate an LDAP connection with the specified directory server.
Action
• Verify that the configured directory server is the correct host.
• Verify that iLO has a clear communication path to the directory server through port 636
(consider any routers or firewalls between iLO and the directory server).
• Verify that any local firewall on the directory server is enabled to allow communications
through port 636.
Connect using SSL test reports a failure
Symptom
The Connect using SSL test reports the status Failed.
Cause
The SSL handshake and negotiation between iLO and the directory server were unsuccessful.
Action
• Enable the directory server for SSL negotiations.
• If you are using Microsoft Active Directory, verify that Active Directory Certificate Services is
installed.
Bind to Directory Server test reports a failure
Symptom
The Bind to Directory Server test reports the status Failed.
Cause
iLO failed to bind the connection with the specified user name or an anonymous bind.
Action
• Verify that the directory server allows anonymous binding.
• If you entered a user name in the test boxes, verify that the credentials are correct.
To Next Page
Loading...
