58
Supported storage components
The Storage Information page displays information about the following storage components:
• Smart Array controllers, drive enclosures, the attached logical drives, and the physical drives
that constitute the logical drives.
• NEC and third-party storage controllers that manage direct-attached storage, and the
attached physical drives.
iLO 5 supports the following products:
◦ M.2 SSD Enablement Kit
◦ 12G SAS Expander
◦ Dual 8GB MicroSD EM USB Kit
◦ NVMe drives
Smart Array controllers are listed first on the page, followed by other NEC Corporation and
third-party storage controllers.
Smart Array details
iLO displays information controllers, enclosures, logical drives, and physical drives.
iLO can monitor 256 physical drives total and 256 logical drives total.
Controllers
This section provides the following details for each Smart Array controller.
• Controller location—Slot number or system board
• Top-level controller status (displayed on the left of the controller location)—A combination
of the controller hardware status and the status of cache modules, enclosures, and physical,
logical, and spare drives associated with the controller. If the controller hardware status is
OK, and any associated hardware has a failure, the top-level controller status changes to
Major Warning or Degraded, depending on the failure type. If the controller hardware has
a Failed status, the top-level controller status is Failed.
• Controller Status—Controller hardware status (OK or Failed)
• Serial Number
• Model
• Firmware Version
• Controller Type
• Cache Module Status
• Cache Module Serial Number
• Cache Module Memory
• Encryption Status—Indicates whether encryption is enabled in the controller.
The following values are possible:
◦ Enabled
◦ Not Enabled
◦ Enabled—Local Mode—This value is displayed when you do not use a remote key
To Next Page
Loading...
Need help?
General