92
Prerequisites
• Configure iLO Settings privilege
• An iLO license that supports this feature is installed.
Procedure
1. Create a set of systems by using the filters on the iLO Federation pages.
2. Click iLO Federation in the navigation tree, and then click the Group Configuration tab.
The filters you apply when you create a set of systems are listed at the top of the page. To
remove a filter, click the filter name.
If no iLO Federation groups exist, this page displays the following message: There are no
configured groups. Use the Setup page to create a group.
3. Select a group from the Selected Group menu.
All of the systems in the selected group that meet the selected filter criteria will be added to
the new group.
4. Enter the following information:
• Group Name—The group name, which can be 1 to 31 characters long.
• Group Key—The group password, which can be from the configured minimum
password length to 31 characters long.
• Group Key Confirm—Confirm the group password.
5. Select from the following privileges:
• Administer User Accounts
• Remote Console Access
• Virtual Power and Reset
• Virtual Media
• Configure iLO Settings
• Login Privilege
For more information about the available privileges, see iLO Federation group privileges.
This step defines the privileges that members of the group have for configuring the other
members of the group.
6. Optional: Enter the Login Name and Password for a user account on the remote systems
you want to manage.
This information is required if the selected group does not have the Configure iLO Settings
privilege on the remote systems you want to manage.
To enter credentials for multiple remote systems, create a user account with the same login
name and password on each system.
7. To save the configuration, click Create Group.
The group creation process takes a few minutes. The group will be fully populated within the
amount of time configured for the Multicast Announcement Interval.
To Next Page
Loading...
Need help?
General