– 8 –
CHAPTER 1 INTRODUCTION
Each communication using LAN1 as its interface is listed in the table below, where relationships between each
application and socket are shown.
Note 1: Internal PHI may use LAN2 for communication with MG(PRI), which depends on your setting.
Application Protocol Port No. IP Address
Registration by Proprietary Protocol UDP 3456 ACT
Registration by SIP UDP 5060 ACT/System #0/System #1
Internal PHI
Note 1 UDP 64000
ACT
NMS TCP 60060
Receiving Health Check from SR-MGC (Server) UDP 60110
Sending Health Check to SR-MGC (Client) UDP 60120
SR-MGC Charge MGC Side TCP 60140
SR-MGC Charge SR-MGC Side TCP 60150
Internal PHE UDP 60130
Internal PHF UDP 60180
FTP TCP 20/21
System #0/System #1
SSH TCP 22
Telnet TCP 23
HTTP TCP 80
To Next Page
Loading...
