NEC UNIVERGE SV7000 - Page 331

– 315 –
ACDCCV : Assignment of ACD CCV Data
4. Assignment and Deletion Procedure
These flow diagrams show the procedure used to assign and delete Call Control Vectors.
Figure 6-5 Assigning and Removing Call Control Vectors
WARNING:
1
2
3
4
1
2
3
5
1
2
3
4
5
4
5
END
END
START
START
AADT/AADTN
ASDT
ACDPLT
ACDSPL
ACDCCV
ACDCCV
ACDSPL
ASDT
AADT/AADTN
1
2
3
4
5
DESCRIPTION
Assign data for announcement trunks referenced by the CCV.
Assign station data for any station referenced by the CCV.
Assign a pilot number to go to the CCV or to a Week Schedule
that references the CCV.
Assign data for any splits referenced by the CCV.
Assign the CCV.
Remove the CCV.
Remove the split(s) referenced by the CCV.
Remove the pilot number(s) that go to the CCV or to a Week
Schedule that references the CCV.
Remove the station data for any station referenced by the CCV.
Remove the data for any announcement trunks referenced
ACDPLT
Some of these may not need to be deleted if being
used by other Splits, CCV, etc.
by the CCV.