EasyManua.ls Logo

NETGEAR Nighthawk D7000 - Chapter 10 Manage the WAN and LAN Network Settings; Change the Physical WAN Connection Preference

NETGEAR Nighthawk D7000
313 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Manage the WAN and LAN Network Settings
This chapter describes how you can manage the WAN and LAN network settings of the modem router.
The chapter includes the following sections:
• Change the Physical WAN Connection Preference on page 210
• Enable and Configure a VLAN on page 212
• Enable Bridge Mode for IPTV Devices on page 215
• Manage the WAN Security Settings on page 216
• Set Up a Default DMZ Server on page 217
• Manage NAT Filtering on page 218
• Manage the SIP Application-Level Gateway on page 219
• Manage the Modem Router’s LAN IP Address Settings on page 219
• Manage the Router Information Protocol Settings on page 221
• Manage Reserved LAN IP Addresses on page 222
• Change the Modem Router’s Device Name on page 225
• Manage the DHCP Server Address Pool on page 225
• Disable the Built-In DHCP Server on page 227
• Set Up and Manage Custom Static Routes on page 228
210

Table of Contents