The user name is admin.The default password is password. The user name and password are
case-sensitive.
4. Click the OK button.
The BASIC Home page displays.
5. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
6. Click the Add button.
7. To make the route private, select the Private check box.
A private static route is not reported in RIP.
8. To prevent the route from becoming active after you click the Apply button, clear the Active check
box.
In some situations, you might want to set up a static route but keep it disabled until a later time. By
default, the Active check box is selected and a route becomes active after you click the Apply button.
9. Enter the settings as described in the following table.
DescriptionField
Enter the IP address for the final destination of the route.Destination IP Address
Enter the IP subnet mask for the final destination of the route.IP Subnet Mask
If the destination is a single host, enter 255.255.255.255.
Manage the WAN and LAN Network Settings
229
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
To Next Page
Loading...
Need help?
General
Weight and Dimensions
