Safety Precautions
vii
Safety Precautions
Although this product is designed and manufactured to be completely safe during use, incorrect usage or
failure to follow the safety instructions provided may cause personal injury or property damage. To ensure
correct usage, carefully read this manual and the instruction manuals of products used together before using
the product. Be sure to read and observe the safety precautions described at the beginning of each manual.
Do not discard this manual and keep it handy for easy reference.
Meaning of Symbols Used on the Product
The symbol appearing on the product indicates the need for caution at all times during use. Always refer to
the instruction manual and read the relevant instructions before manipulating any part to which the symbol
has been affixed.
Symbol Description
Biohazard
This symbol label is attached on the top or front surface of the stage to remind the user of the
following precautions:
• Spillage of a specimen from a vessel onto the microscope, presents a biohazard risk.
• To avoid biohazard contamination, do not touch the contaminated portion with your bare hands.
• Decontaminate the contaminated portion according to the standard procedure of your laboratory.
Manual stage Plain stage Gliding stage
Caution for heat
This symbol label is attached on the top surface of the optical path cover on the top of the
illumination pillar, on the top surface of the TI2-D-SF filter slider for dia illumination, and on the
back surface of the D-LH/LC precentered lamphouse. When the D-LH/LC is used as the
dia-illumination source, this symbol reminds the user of the following precautions:
• The lamp and lamphouse, the top surface of the optical path cover, and the top surface of the
filter slider for dia-illumination become hot while the lamp is lit or immediately after it goes out.
• To avoid the risk of burns, do not touch the lamp or lamphouse, the top surface of the optical
path cover, or the top surface of the filter slider for dia-illumination while the lamp is lit or
immediately after it goes out.
• Make sure the lamp, the lamphouse, and the air vents of the HG precentered fiber illuminator
have cooled sufficiently before attempting to replace the lamp.
S.
F.
The top surface of the optical path
cover
S.
F.
The top surface of
the TI2-D-SF filter slider for dia
illumination
Rear surface of the D-LH/LC
precentered lamphouse
When a TI2-D-LHLED LED
lamphouse for dia-illumination is used
When the TI2-D-SF filter slider for dia illumination and the D-LH/LC
precentered lamphouse are used
Biohazard symbol
Biohazard
symbol
Biohazard
symbol
Hot surface
symbol
Hot surface
symbol
Hot surface
symbol
To Next Page
Loading...
Need help?
General
