File System Management
124
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
scp
Syntax scp local-file-url destination-file-url [router router-instance] [force]
scp local-file-url destination-file-url [service service-name] [force]
Context file
Description This command copies a local file to a remote host file system. It uses ssh for data transfer,
and uses the same authentication and provides the same security as ssh. When the
command is entered, the following prompt appears:
“Are you sure (y/n)?”
The destination must specify a user and a host.
Parameters local-file-url — the local source file or directory (see Table 14 for parameter descriptions)
destination-file-url — the destination file:
Values
router-instance — specifies the router name or service ID
Values router-name: Base, management
service-id: 1 to 2147483647
Default Base
user@hostname:file-path 255 characters maximum
user: the SSH user, 32 characters
maximum
hostname: dns-name | ipv4-address |
“[”ipv6-address “]” (IPv6
address must be enclosed in
square brackets)
dns-name: 128 characters maximum
ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x: [0..FFFF]H
d: [0..255]D
interface: the interface name,
32 characters maximum,
mandatory for link local
addresses
file-path: the destination file path, 200
characters maximum,
directory length is 99
characters maximum each
To Next Page
Loading...
