Nokia 7705 - Page 125

Basic System Configuration Guide File System Management
Edition: 01 3HE 11010 AAAC TQZZA 125
service-name — specifies the service name, 64 characters maximum
force — forces an immediate copy of the specified file
file scp local-file-url destination-file-url [router router-instance | service-name
service-name] force executes the command without displaying a user prompt
message
shutdown
Syntax [no] shutdown [active] [standby]
[no] shutdown flash-id
Context file
Description This command shuts down (unmounts) the specified CSMs.
Use the no shutdown [active] [standby] command to enable one or both CSMs.
Use the no shutdown flash-id command to enable a compact flash (cf3: on all platforms; cf1:
or cf2: on the 7705 SAR-18) on the CSM. The no shutdown command can be issued for a
specific slot when no compact flash is present. When a compact flash is installed in the slot,
the device will be activated upon detection.
In redundant systems, use the no shutdown command on cf3: on both CSMs in order to
facilitate synchronization. See the synchronize command in the config>redundancy
context.
The shutdown command must be issued prior to removing a compact flash. If no parameters
are specified, the drive referred to by the current working directory will be shut down.
LED status indicators — the following states are possible for the compact flash:
Operational: If a compact flash is present in a drive and operational (no shutdown), the
respective LED is lit green. The LED flickers when the compact flash is accessed. Do not
remove the compact flash during a read/write operation.
State: admin = up, operational = up, equipped
Flash defective: If a compact flash is defective, the respective LED blinks amber to reflect
the error condition and a trap is raised.
State: admin = up/down, operational = faulty, equipped = no
Flash drive shut down: When the compact flash drive is shut down and a compact flash is
present, the LED is lit amber. In this state, the compact flash can be ejected.
State: admin = down, operational = down, equipped = yes
No compact flash present, drive shut down: If no compact flash is present and the drive
is shut down, the LED is unlit.