Boot Options
184
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Default duplex full — full duplex operation
Parameters full — sets the link to full duplex mode
half — sets the link to half duplex mode
fips-140-2
Syntax [no] fips-140-2
Context bof
Description This command is used to enable the node to support security level 1 of Federal Information
Processing Standards 140 series, version 2 (FIPS-140-2). This mode limits the use of
cryptographic algorithms on both the CSM and data plane to only those that are in
accordance with FIPS-140-2. The node must be rebooted after executing this command in
order for the node to begin operating in FIPS-140-2 mode.
The no form of the command disables support for security level 1 of FIPS-140-2 on the node.
Default no fips-140-2
speed
Syntax speed speed
Context bof
Description This command configures the speed for the CSM Management port when autonegotiation is
disabled in the running configuration and the Boot Option File (BOF).
If the port is configured to autonegotiate, this parameter is ignored.
Default speed 100 — 100 Mb/s operation
Parameters 10 — sets the link to 10 Mb/s speed
100 — sets the link to 100 Mb/s speed
static-route
Syntax [no] static-route ip-prefix/prefix-length next-hop ip-address
Caution: Before using this command, the operator much ensure that no current
configuration exists in the configuration file that is not supported in FIPS-140-2 mode.
Failing to remove unsupported configurations will result in the node being unable to boot up.
To Next Page
Loading...
