Basic System Configuration Guide Boot Options
Edition: 01 3HE 11010 AAAC TQZZA 185
Context bof
Description This command creates a static route entry for the CSM Management port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes
are only used by traffic generated by the CSM Management port. To reduce configuration,
manual address aggregation should be applied where possible.
A static default route (0.0.0.0/0) cannot be configured on the CSM Management port. A
maximum of 10 IPv4 and 10 IPv6 static routes can be configured on the CSM Management
port.
Each unique next hop of active static routes configured on both the active and standby CSM
Management ports are tested every 60 seconds. If the next hop is unreachable, an alarm is
raised. The alarm condition is cleared when the preferred static route becomes reachable.
The no form of the command deletes the static route.
Default n/a
Parameters ip-prefix/prefix-length — the destination address requiring the static route
Values ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
ipv6-prefix-length 0 to 128
next-hop ip-address — the next hop IP address used to reach the destination
Values ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
To Next Page
Loading...
