System Management
382
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
6.13.2.1.8 LLDP System Commands
Refer to the 7705 SAR Interface Configuration Guide, “7705 SAR Interfaces”, for
LLDP Ethernet port commands.
lldp
Syntax lldp
Context config>system
Description This command enables the context to configure system-wide Link Layer Discovery Protocol
(LLDP) parameters.
message-fast-tx
Syntax message-fast-tx time
no message-fast-tx
Context config>system>lldp
Description This command configures the interval between LLDPDU transmissions by the LLDP agent
during a fast transmission period.
The fast transmission period begins when a new neighbor is detected. During the fast
transmission period, LLDPDUs are transmitted at shorter intervals than the standard tx-
interval to ensure that more than one LLDPDU is sent to the new neighbor. The first
transmission occurs as soon as the new neighbor is detected. The length of the fast
transmission period is determined by the number of LLDPDU transmissions (configured by
the message-fast-tx-init command) and the interval between them.
The no form of the command reverts to the default value.
Default 1
Parameters time — specifies the interval between LLDPDU transmissions in seconds
Values 1 to 3600
To Next Page
Loading...
