Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 383
message-fast-tx-init
Syntax message-fast-tx-init count
no message-fast-tx-init
Context config>system>lldp
Description This command configures the number of LLDPDUs to send during a fast transmission period.
The fast transmission period begins when a new neighbor is detected. During the fast
transmission period, LLDPDUs are transmitted at shorter intervals than the standard tx-
interval to ensure that more than one LLDPDU is sent to the new neighbor. The first
transmission occurs as soon as the new neighbor is detected. The length of the fast
transmission period is determined by the number of LLDPDU transmissions and the interval
between them (configured by the message-fast-tx command).
The no form of the command reverts to the default value.
Default 4
Parameters count — specifies the number of LLDPDUs to send during the fast transmission period
Values 1 to 8
notification-interval
Syntax notification-interval time
no notification-interval
Context config>system>lldp
Description This command configures the minimum time between change notifications. A change
notification is a trap message sent to SNMP whenever a change occurs in the database of
LLDP information.
The no form of the command reverts to the default value.
Default 5
Parameters time — specifies the minimum time, in seconds, between change notifications
Values 5 to 3600
To Next Page
Loading...
