Nokia 7705 - Page 384

System Management
384
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
reinit-delay
Syntax reinit-delay time
no reinit-delay
Context config>system>lldp
Description This command configures the time before reinitializing LLDP on a port.
The no form of the command reverts to the default value.
Default 2
Parameters time — specifies the time, in seconds, before reinitializing LLDP on a port
Values 1 to 10
tx-credit-max
Syntax tx-credit-max count
no tx-credit-max
Context config>system>lldp
Description This command configures the maximum number of consecutive LLDPDUs that can be
transmitted at any time.
The no form of the command reverts to the default value.
Default 5
Parameters count — specifies the maximum number of consecutive LLDPDUs transmitted
Values 1 to 100
tx-hold-multiplier
Syntax tx-hold-multiplier multiplier
no tx-hold-multiplier
Context config>system>lldp
Description This command configures the multiplier of the transmit interval defined by the tx-interval
command.
The transmit interval time multiplied by the tx-hold-multiplier is the TTL value in the
LLDPDU. The TTL value determines the amount of time the receiving device retains LLDP
packet information in local information databases before discarding it.