System Management
436
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
poe
Syntax poe
Context show>system
Description This command shows a summary of the PoE status of each PoE capable port in the system.
Output The following output is an example of PoE status information, and Table 44 describes the
fields.
Output Example
A:# show system poe
===============================================================================
PoE Information
===============================================================================
PoE Maximum Power Budget : 83.8 watts
PoE Power Committed : 65.0 watts
PoE Power Available : 18.8 watts
PoE Power In Use : 0.0 watts
===============================================================================
PoE Port Information
===============================================================================
Interface PoE PoE Maximum Power
Mode Detection Power In Use
-------------------------------------------------------------------------------
1/1/5 Standard Searching 15.4 watts 0.0 watts
1/1/6 Disabled Disabled 0.0 watts 0.0 watts
1/1/7 Plus Searching 34.2 watts 0.0 watts
1/1/8 Standard Searching 15.4 watts 0.0 watts
===============================================================================
A:# show system poe
R Yes — the NTP peer or server has been reached at least once in
the last 8 polls
No — the NTP peer or server has not been reached at least once
in the last 8 polls
Offset The time between the local and remote UTC time, in milliseconds
Table 43 Show System NTP Output Fields (Continued)
Label Description
To Next Page
Loading...
