Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 437
ptp
Syntax ptp
Context show>system
Description This command enters the show PTP context.
clock
Syntax clock clock-id [bmc] [detail] [standby] [statistics] [summary] [timestamp] [unicast]
Context show>system>ptp
Description This command displays PTP clock information.
Timestamp is information is not available for the 2-port 10GigE (Ethernet) module.
Parameters clock-id — specifies the clock ID of this PTP instance
Values 1 to 16 for PTP clocks that use IPv4 encapsulation
csm for a PTP clock that uses Ethernet encapsulation
bmc — displays information about the best master clock algorithm configured for each
PTP peer. This command only applies when the clock-id parameter value is 1 to 16.
Table 44 Show System PoE Status Output Fields
Label Description
PoE Maximum Power
Budget
The maximum PoE power budget available for the system.
PoE Power
Committed
The total PoE power that has been configured on all POE or PoE+
ports on the system.
PoE Power Available The amount of PoE power available to be configured on
additional PoE or PoE+ ports on the system.
PoE Power In Use The total PoE power currently being used by all PoE or PoE+
configured ports on the system.
PoE Mode Indicates whether the port is using standard PoE or PoE+.
If the PoE function is turned off, the mode is Disabled.
PoE Detection Indicates the detection state of the PoE port.
Maximum Power The maximum PoE power available on the port.
Power in Use The amount of PoE power currently being used on the port.
To Next Page
Loading...
