CLI Usage
76
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
management-access-filter
Syntax management-access-filter
Context monitor
Description This command enables the context to configure criteria to monitor management access
filters. Management access filters control all traffic. They can be used to restrict management
of the 7705 SAR by other nodes outside specific (sub)networks or through designated ports.
ip
Syntax ip entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description This command enables IP filter monitoring. The statistical information for the specified IP filter
entry is displayed at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IP filter. The subsequent
statistical information listed for each interval is displayed as a delta to the previous screen
output.
When the keyword rate is specified, the rate per second for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters entry-id — displays information for the specified filter entry ID
Values 1 to 9999
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — displays the rate per second for each statistic instead of the delta
To Next Page
Loading...
