CLI Usage
88
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters sap-id — identifies the SAP for the service
The sap-id can be configured in one of the formats described in Table 11. The range
of values for the parameters follow the table.
Table 11 SAP ID Configurations
Type Syntax Example
port-id slot/mda/port[.channel] 1/1/5
bridge slot/mda/<bridge-id.branch-id> 1/5/16.10
null [port-id | bundle-id | lag-id | aps-id | mw-
link-id]
port-id: 1/1/3
bundle-id: bundle-ppp-1/1.1
lag-id: lag-1
aps-id: aps-1
mw-link-id: mw-link-1
dot1q [port-id | lag-id | aps-id | mw-link-
id]:qtag1
port-id:qtag1: 1/1/3:100
lag-id: lag-1:10
aps-id: aps-1
mw-link-id: mw-link-1
qinq [port-id | lag-id]:qtag1.qtag2 port-id:qtag1.qtag2: 1/1/3:100.30
lag-id: lag-1:10.10
atm [port-id | aps-id][:vpi/vci | vpi |
vpi1.vpi2]
1
port-id: 1/1/1 or 1/1/1.1 (for T1/E1
channelized ports)
aps-id: aps-1
vpi/vci: 16/26
vpi: 16
vpi1.vpi2: 16.22
lag lag-id lag-2
frame [port-id| aps-id]:dlci 1/1/1
aps-id: aps-1
dlci: 16
frame relay [port-id]:dlci 1/1/1
dlci: 16
cisco-hdlc slot/mda/port.channel 1/1/1.3
To Next Page
Loading...
